The power supply is a a 48V 600W and can run 5 axis simultaneously.Runs great. The G540 and5th axis db9 connector is set up with pins1 and 5 for I-set and pins 6-9 for the standard G540 motor pin out. The rear panel has a fused IEC power entry module, a 3 prong receptacle for loads up to 700 watts and will shut off if the ESTOP is pressed. The DB9 connectors are for is for the 5th axis motor, VFD, Digitizing/index/toolsetter, 2 outputs for external relays outputs, XYZ home switch The front panel have a lighted on off switch, and ESTOP switch and an output engage/disengage switch that allows the user to manually move any of the dual shaft motors. The control box is designed with db9 female connector.
With the ESS it is easy to run 5 axis or at addition expense we can add a 6th axis.No parallel port is required. This is the only 5 axis control box using the terrific Gecko Drive products with the Warp9TD Ethernet Smooth Stepper (ESS).Camtronics has built many 2,3,4,5,6 and 8 axis systems in the past. All 5 axis are capable of running 3.5A or lower current motors. Introducing the new Camtronics Inc 5 axis GeckoDrive G540 control box using the Ethernet Smooth Stepper (ESS) with a whopping 48V12.5 A 600W power supply. Camtronics Can provide just about any G540 configuration you could want. Camtronics was the first Beta tester of the G540 and help Mariss at Gecko drive resolve some issues with the prototypes.
No other seller has been around that long!. Buy American!!!!!ĬamtronicsInc has been in the CNC business since July 1993.
with the dip switches set to 1/2 step,1/4 step and 1/16 step. One Blew after 5 minutes at 5A! I tested a second one and found that on an ordinary parallel port that I could only getmediocrespeed.